Rf Transmitter Functions - White Mountain Hearth DVX36FP32CLN-1 Installation Instructions And Owner's Manual

FIRST USE OF TRANSMITTER
Status
Begin communication between transmitter and receiver/valve.
Transmit unique code.
Confirm recognition between transmitter and receiver/valve.
Chose Remote or Local operation.
Operation in the Remote Position
AUTO Mode
With the control in the AUTO mode, the flame in the main burner will turn on, off, or change height based on the heat needed to maintain the set temperature.
Status
Set to AUTO.
Change set temperature.
Flame.
Fan.
To Set Delay Timer.
CAUTION
Properly Damage Hazard.
Excessive heat can cause property damage.
In AUTO mode, the main burner will cycle indefinitely to maintain the set temperature. Keep the transmitter in a heated living space to make sure that the main
burner is not on continuously.
On Mode
When the control is in the ON mode, the flame and fan levels and the delay timer are changed with the UP and DOWN arrow keys.
Status
Set to ON.
Flame.
Fan.
Delay Time.
OFF Mode
The flame in the main burner will turn off and the room temperature
will be displayed in the remote window.
Operation in the LOCAL Mode.
NOTE: Remote/Local switch on the receiver/valve must be in the LOCAL position.
FAN
Flame height and fan speed both go to the highest position.
Other Functions:
Change between Fahrenheit and Celsius temperature units.
Fan Override during AUTO Mode.
Disable thermostat function in the AUTO Mode.
Page 56

RF TRANSMITTER FUNCTIONS

Action
Move LOCAL/REMOTE Switch to LOCAL position for at least two
seconds; then move switch to the REMOTE position.
Press Fan or Flame key within 30 seconds.
Observe LED turns on for one second.
Move LOCAL/REMOTE switch to LOCAL or leave in REMOTE.
Action
Press MODE button until mode is AUTO.
Press UP or DOWN key to change set temperature.
Automatically changes.
Automatically changes.
Press TIME key followed by either an UP or DOWN arrow key.
Action
Press MODE button until mode is ON.
Press FLAME button and press UP or DOWN arrow key to change flame
height.
Press FAN button and press UP or DOWN arrow key to change fan speed.
Press DELAY TIMER button and press UP or DOWN key to change timer.
Press MODE until mode is OFF.
In LOCAL mode, to turn flame on/off, rotate manual knob from ON to
PILOT position.
Press UP and DOWN arrow keys at the same time and hold for at least
three seconds.
Press FAN button, and press UP or DOWN arrow key to change the fan
speed.
Press the TIME, DOWN and FLAME arrow keys at the same time and hold
for at least three seconds.
25047-0-0309