White Mountain Hearth DVX36FP32CLN-1 Installation Instructions And Owner's Manual page 41

15. Place Front Center Log (L) between third and fourth grates on
the burner. The short "Y" branch will point left and the bottom
of the "Y" resting on the firebox bottom.
16. Place Front Right Log (M) on the fifth grate from the left with
the top resting on (K) Log.
ATTENTION: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
17. After all logs are properly positioned, place small "dime" size
pieces of Rockwool lightly across the front round "blueflame"
ports. Place the ember material (Rockwool pieces) side by side.
Do not stack more than one layer of embers across the burner
ports. See Figure 61.
25047-0-0309
LOG PLACEMENT (13 LOG SET)
Figure 61
18. Replace glass door onto firebox.
19. Secure the two glass frame spring clamps at bottom of
firebox.
20. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
21. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
WARNING: Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
Attention: Refer to Log Identification Page 38, and Figures 63
and 64 to order logs.
Caution: If a log is broken, cracked or chipped, order a
replacement log. See page 42.
Figure 62
Page 41