Motorola DS6708 Product Reference Manual page 31

Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Fast warble beep
Low/high beeps
ADF Programming: Normal Data Entry. Duration of tones are short.
High/low beeps
Low/low beeps
High/high beeps
High/low/high/low beeps
High/low/low beeps
Low beep
Low/high/high beeps
ADF Programming: Error Indications. Duration of tones are very long.
Low/high/low/high beeps
Low/high/low beeps
Low/high beeps
Host Specific
USB only
4 short high beeps
Low/medium/high beeps
upon scanning a USB device
type
Low/medium/high beeps
occur more than once.
RS-232 only
1 short high beep
Aborting MPDF sequence.
Flushing an already empty MPDF buffer.
Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the End of Message bar code.
Enter another criterion or action, or scan the Save Rule bar code.
Rule saved. Rule entry mode exited.
All criteria or actions cleared for current rule, continue entering rule.
Delete last saved rule. The current rule is left intact.
All rules are deleted.
Out of rule memory. Erase some existing rules, then try to save rule again. (It is not
necessary to re-enter the current rule.)
Cancel rule entry. Rule entry mode exited because of an error or the user asked to
exit rule entry.
Entry error, wrong bar code scanned. Re-enter criterion or action. All previously
entered criteria and actions are retained. Criteria or action list is too long for a rule.
Digital scanner has not completed initialization. Wait several seconds and scan
again.
Communication with the bus must be established before the digital scanner can
operate at the highest power level.
The USB bus can put the digital scanner in a state where power to the digital
scanner is cycled on and off more than once. This is normal and usually happens
when the PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled.
Indication
Scanning 2 - 3