Advertisement
G. Specifications setting
Use SIM26 to set to the specifications according to the customer's
request.
SIM No
26
6
Destination setting
To customize one of the following items after destination setting,
change the set value of the item.
SIM No
Toner save mode enable/disable setting
18
* For the other destinations, this setting is made by
26
the user program.
53
Auto color calibration enable/disable setting
3.Image quality check
A. Execution items
Execute the checking items about the printing quality. Regarding
the specific procedures for the printing quality, refer to the Service
Manual [5] ADJUSTMENT.
B. Description
(1) Print engine image distortion confirmation and
adjustment
This adjustment performs the print engine image distortion adjust-
ment, the OPC drum phase adjustment, and the color registration
adjustment simultaneously.
1) Enter SIM50-22 mode and perform the auto registration adjust-
ment by pressing [EXECUTE] key.
Content
Content
Successfully Finished
Error occurs
MX-C301 MX-C301/C301W(MAIN UNIT) 2 – 4
2) When the adjustment is completed, [EXECUTE] key returns to
the normal display, and the value of the adjustment result is dis-
played.
The current skew level for each color is displayed on the SKEW
display section.
3)
Make test print in the simulation mode for checking whether
the void, off-center and printing quality are correct.
If the test results are not correct, refer to [5] ADJUSTMENT
from the Service Manual and perform the adjustments.
- Void ; SIM50-01/50-10
- Printing position ; SIM50-10
- Off-center, Registration ; SIM50-20
When the result of the void and the printing position are not
suitable, perform [ADJ4] by referring the [5] ADJUSTMENT of
the Service Manual.
When the result of the off-center is not adequate, perform
[ADJ5] by referring the [5] ADJUSTMENT of the Service Man-
ual.
- Printing quality ; SIM64-5
When the result of the print quality is not good, perform
[ADJ10] by referring the [5] ADJUSTMENT of the Service
Manual.
Advertisement
