Removing And Replacing The Led Status Light Cable - IBM 7212 102 Service Manual

Removing and Replacing the LED Status Light Cable

Use the following steps to remove the LED status light:
1. Perform the cover removal procedure. Refer to "Removing and Replacing the
2. Perform the power switch assembly removal procedure. Refer to "Removing
3. The status LED cables are mounted to the power switch bracket. Push the
4. Disconnect the LED cable from the status interface card.
Figure 17. Removing the Status Interface Cable Assembly
To replace the status interface cable assembly, reverse this procedure.
Note: Ensure the green LED is positioned above the yellow LED in the bracket.
Cover" on page 28.
and Replacing the Power Switch Assembly" on page 36.
round LED lights forward and down and guide them carefully through the
hole in the bottom of the switch bracket to free the cable.
RBBTW510-0
Chapter 3. Removal and Replacement
37