IBM 7212 102 Service Manual page 36

Step 19
You are here because the host system is an RS/6000 or pSeries host system.
This step verifies that the 7212 Storage Enclosure has been properly configured to
the host system.
Check the configuration of the 7212 Storage Enclosure to the host system software
by doing the following:
1. Log into the host system (AIX operating system).
2. At the system prompt, type
hdisk0
hdisk1
hdisk2
rmt0
rmt1
cd1
cd2
rmt2
Figure 7. Screen Display of SCSI Devices Attached to the host system
3. From the list of SCSI devices, identify the 7212 Storage Enclosure drive
Is the 7212 Storage Enclosure properly configured to the host system?
NO
YES
22
7212 Storage Device Enclosure Service Guide
Note: You must have root authority to install or remove the 7212 Storage
Enclosure from the system. To obtain root authority, see your system
administrator.
lsdev -Cs scsi
and press Enter. The command lists all of the SCSI devices that are connected
to the host system. Figure 7 shows an example of the screen that displays. The
screen lists:
1
Device name
2
Device Status
3
SCSI adapter slot number
Available 00-00-0S-0,0
Available 00-02-01-2,0
Available 00-02-01-3,0
Available 00-02-01-4,0
Available 00-02-01-5,0
Available 00-03-01-1,0
Available 00-03-01-2,0
Available 00-03-01-3,0
features. These are listed as:
v Differential SCSI 4mm Tape Drive
v SCSI 4mm Tape Drive
v SCSI DVD-RAM Drive
If the status of the 7212 Storage Enclosure drive feature is displayed as
Available, the device has successfully been configured. If the status is not
displayed as Available, refer to your host system manuals.
Go to Step 20.
Go to Step 20 to verify that the problem is fixed
4
SCSI address (begins with 7th digit)
5
Description of the SCSI device
2.0GB SCSI Disk Drive
4.5GB 16 Bit SCSI Disk Drive
16 Bit SCSI Disk Drive
Differential SCSI 8mm Tape Drive
4.0 GB 4mm Tape Drive
SCSI Multimedia CD-ROM Drive
16 Bit LVD SCSI DVD-ROM Drive
LVD SCSI 4mm Tape Drive