Operation - EGO CS1400E Operating Manual

OPERATION

WARNING:
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields. Failure to do so could
result in objects being thrown into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recommended by the
manufacturer of this product. The use of attachments or accessories not recommended
can result in serious personal injury.
Before each use, inspect the entire product for damaged, missing, or loose parts, such
as screws, nuts, bolts, caps, etc. Securely tighten all fasteners and caps and do not
operate this product until all missing or damaged parts are replaced.
APPLICATION
You may use this product for basic felling, limbing, pruning and woodcutting of lumber
and trees.
FILLING BAR AND CHAIN LUBRICANT
WARNING:
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool before filling oil.
WARNING:
Do not smoke or bring any fire or flame near the oil or the chain saw.
Oil may spill and cause a fire.
NOTICE:
The chain saw is not filled with oil at the time of purchase. It is essential
to fill the tank with oil before use. Operating the chain saw without chain oil or when
the oil level is below the minimum mark will result in damage to the chain saw. Chain
life and cutting capacity depend on optimum lubrication. The chain is automatically
lubricated with chain oil during operation.
1. Remove the battery pack from the chain saw.
2. Clean the oil tank cap and the area around it to ensure that no dirt falls into the oil
tank.
56V LITHIUM-ION CORDLESS CHAIN SAW
27