Assembly - EGO CS1400E Operating Manual

ASSEMBLY

WARNING:
until the parts are replaced. Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
recommended for use with this chain saw. Any such alteration or modification is
misuse and could result in a hazardous condition leading to possible serious personal
injury.
WARNING:
injury, always remove the battery pack from the tool when assembling parts.
ASSEMBLING/REPLACING THE BAR AND CHAIN
WARNING:
sure that the battery pack is removed. Failure to heed this warning could result in
serious personal injury.
WARNING:
components are sharp and may contain burrs.
NOTICE:
When replacing the guide bar and chain, always use the specified bar and
chain combination listed in the section: "Recommended Bar and Chain for this
Chain Saw".
1. Remove the battery pack.
2. Position the chain saw power head
on its side on a firm, flat surface,
so that the side cover is facing
upwards (Fig. 8).
3. Wear gloves. Remove the side cover
by turning the side cover knob
counterclockwise (Fig. 8).
If any parts are damaged or missing, do not operate this product
Do not attempt to modify this product or create accessories not
To prevent accidental starting that could cause serious personal
Before performing any assembly, adjustment or maintenance, make
Always wear gloves when handling the bar and chain; these
8
Side Cover
56V LITHIUM-ION CORDLESS CHAIN SAW
Chain Saw Chain Tensioning
Power Head Knob
Side Cover Knob
23