Quick Arming; Auto Stay Feature - ADT Safewatch QuickConnect Plus User Manual

When armed in AWAY mode, the system will sound an alarm if a protected door or window is opened,
or if any movement is detected inside the premises. You may leave through the entrance door during
the exit delay period without causing an alarm. You may also re-enter through the entrance door, but
you must disarm the system within the entry delay period or an alarm will occur.

Auto Stay Feature

If this feature is enabled by installer, the system, when armed AWAY from the Safewatch
QuickConnect Plus keypad or a Wireless Keypad, switches to the STAY mode if the Exit Time expires
and no exit has been made.
NOTE: If the exit route entry/exit sensor is in a check condition or has been bypassed it will result in a loss
of interior protection because the alarm system will arm STAY in this case. Consult with your
installer for servicing of the entry exit zones or to turn off this feature if a check condition on entry
exit zones occurs.

Quick Arming

If Quick Arm was programmed by the installer, you do not need to enter the security code to arm the
system. Instead, simply press and hold down the desired arming key for at least 2 seconds. The
security code must always be used to disarm the system, however.
To arm if Quick Arm is active:
IMPORTANT: The Babysitter Code and Installer Code cannot disarm the system unless it was used to
arm the system. In addition, if the system is armed by pressing and holding the Quick-Arm buttons,
neither the Babysitter Code nor Installer Code can disarm the system.
SECURING THE PREMISES
AWAY or STAY hold down for at least 2 seconds
– 15 –
Arming the System
