Adjusting The Volume - ADT Safewatch QuickConnect Plus User Manual

Adjusting the Volume

The volume level of message playback, system announcements, and status beeps can be changed. You
can also mute system announcements if desired.
To adjust message playback/system announcement volume:
FUNCTION + VOLUME + [3] or [6]
†
[3] = increases volume one level, [6] = decreases volume one level.
Repeat the key sequence until the desired volume level is achieved.
To mute system announcements:
When muted, no system announcements will be made. Recorded messages will be announced, though,
when is pressed.
PLAY
To restore announcement sounding:
Volume level will be restored to the level that was selected prior to muting the sound.
NOTE: If a wireless keypad (e.g., 5827) has been installed and is programmed for quick arming, it cannot
be used to activate message playback or adjust the volume. In this case, you must use the master
keypad to perform these functions.
Message Recording/Playback/Volume Control
†
FUNCTION + VOLUME + OFF
FUNCTION + VOLUME + [3] or [6]
– 21 –
USER FUNCTIONS