Grandstream Networks GXP1400 User Manual page 25

Call Progress Tones
Intercom User ID
Disable Call Waiting
Disable Call
Waiting Tone
Disable Direct IP Calls
Use Quick IP Call Mode
Disable Conference
Disable DND Button
Disable Transfer
Auto-Attended Transfer
Configuration via
Keypad Menu
Grandstream Networks, Inc.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Using these settings, users can configure ring or tone frequencies based on
parameters from local telecom. By default, they are set to North American standard.
Frequencies should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of silence. In
order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms
and a pause of OFF ms and then repeat the pattern. Up to three cadences are
supported.
Configure intercom user ID when intercom is used.
Default is "No". If set to "Yes", the call waiting feature will be disabled.
Default is "No". If set to "Yes", the call waiting tone will be disabled.
Default is "No". If set to "Yes", direct IP calls will be disabled.
Dial an IP address under the same LAN/VPN segment by entering the last octet in
the IP address.
In the Advanced Settings page there is an option "Use Quick IP-call mode". Default
setting is "No". When set to "Yes", and #XXX is dialed, where X is 0-9 and XXX
<=255, phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc
comes from the local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call
Mode for details.
Default is "No". If set to "Yes", conference will be disabled.
Default is "No". If set to "Yes", the "DND" button on keypad will be disabled.
Default is "No". If set to "Yes", transfer will be disabled.
Default is "No". If set to "Yes", the phone will use attended transfer by default.
Configures the access control of configurations via the phone keypad menu. There
are three modes:
•
Unrestricted
•
Basic Settings Only
•
Constraint Mode
GXP1400/1405 User Manual
Firmware version: 1.0.1.67
Page 24 of 34
Last Updated: 05/2011