Grandstream Networks GXP1400 User Manual page 22

Firmware Upgrade and
Provisioning
XML Config File
Password
HTTP/HTTPS User Name The user name for the HTTP/HTTPS server.
HTTP/HTTPS Password
Upgrade Via
Firmware Server Path
Config Server Path
Firmware File
Prefix/Postfix
Config File
Prefix/Postfix
Allow DHCP Option 43
and Option 66 to
override server
Automatic Upgrade
Authenticate Conf File
Enable TR-069
ACS URL
Grandstream Networks, Inc.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Allows the user to select the following options for firmware upgrade:
•
Always Check for New Firmware
•
Check New Firmware only when F/W pre/suffix changes
•
Always Skip the Firmware Check.
Firmware upgrade may take up to 10 minutes depending on network environment.
Do not interrupt the firmware upgrading process.
Note: Grandstream strongly recommends that the user upgrade firmware
locally in a LAN environment if using TFTP to upgrade. Please DO NOT
interrupt the upgrade process (especially the power supply) as this will
damage the device.
The password used for encrypting the XML configuration file using OpenSSL. This
is required for the phone to decrypt the encrypted XML configuration file.
The password for the HTTP/HTTPS server.
This field allows the user to choose the firmware upgrade method: TFTP, HTTP or
HTTPS.
Defines the server path for the firmware server. It can be different from the
Configuration server which is used for provisioning.
Defines the server path for provisioning; it can be different from the firmware server.
Default is blank. If configured, GXP1400/1405 will request the firmware file with the
prefix/postfix and only the firmware with the matching encrypted prefix will be
downloaded and flashed into the phone.
This setting is useful for ITSPs. End user should keep it blank.
Default is blank. If configured, GXP1400/1405 will request the config file with the
prefix/postfix and only the file with the matching encrypted prefix will be downloaded
and flashed into the phone.
This setting is useful for ITSPs. End user should keep it blank.
Default is "Yes". This allows device gets provisioned from the server automatically.
This function is used by ITSP. End user should NOT touch these parameters.
Default is "No". Choose "Yes" to enable automatic HTTP upgrade and provisioning.
In "Check for upgrade every" field, enter the number of minutes to check the HTTP
server for firmware upgrade or configuration changes. When set to "No", the phone
will only perform HTTP upgrade and configuration check once at boot up.
Default is "No". If set to "Yes", configuration file would be authenticated before
acceptance. End user should use default setting.
Default is "No".
URL for TR-069 Auto Configuration Servers (ACS).
GXP1400/1405 User Manual
Firmware version: 1.0.1.67
Page 21 of 34
Last Updated: 05/2011