Figure 75 Menu 3.5 Wireless Lan Setup; Table 48 Menu 3.5 Wireless Lan Setup - ZyXEL Communications ZyAIR G-5100 User Manual

Figure 75 Menu 3.5 Wireless LAN Setup

WLAN Adapter= WLAN 1
Operating Mode= Access Point
Name (SSID)= ZyXEL
Hide Name (SSID)= No
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
WEP Encryption= Disable
Default Key= N/A
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Authen. Method= N/A
The following table describes the fields in this menu.

Table 48 Menu 3.5 Wireless LAN Setup

FIELD
WLAN Adapter Index Press [SPACE BAR] and select a wireless LAN adapter to configure.
Operating Mode
Name (SSID)
Hide Name (SSID)
Channel ID
RTS Threshold
Frag. Threshold
WEP Encryption
Default Key
Chapter 14 LAN Setup
Menu 3.5 - Wireless LAN Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] and select Access Point, Multiple ESS, Bridge /
Repeater or AP + Bridge.
The SSID (Service Set IDentity) identifies the AP to which the wireless stations
associate. Wireless stations associating to the AP must have the same ESSID.
Enter a descriptive name of up to 32 printable 7-bit ASCII characters.
This field is only available when you select Access Point or AP + Bridge in the
Operating Mode field.
Press [SPACE BAR] and select Yes to hide the ESSID in the outgoing data
frame so an intruder cannot obtain the ESSID through passive scanning.
Press [SPACE BAR] to select a channel. This allows you to set the operating
frequency/channel depending on your particular region.
Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value
between 0 and 2432.
This is the maximum data fragment size that can be sent. Enter a value
between 800 and 2432.
Select Disable to allow wireless stations to communicate with the access points
without any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Enter the key number (1 to 4) in this field. Only one key can be enabled at any
one time. This key must be the same on the ZyAIR and the wireless stations to
communicate.
ZyAIR G-5100 User's Guide
Edit MAC Address Filter= No
Edit Roaming Configuration= No
Edit Bridge Link Configuration= N/A
Preamble= Long
802.11 Mode= Mixed
Max. Frame Burst= 650
VLAN ID= 1
Block Intra-BSS Traffic= No
Output Power= 17dBm
141