ZyAIR G-5100 User's Guide
Table 60 Menu 24.2.1 System Maintenance: Information
FIELD
Name
Routing
ZyNOS F/W Version
Country Code
LAN
Ethernet Address
IP Address
IP Mask
DHCP
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
19.2.2 Console Port Speed
You can set up different port speeds for the console port through Menu 24.2.2 – System
Maintenance – Console Port Speed. Your ZyAIR supports 9600 (default), 19200, 38400,
57600 and 115200 bps console port speeds. Press [SPACE BAR] and then [ENTER] to select
the desired speed in menu 24.2.2, as shown in the following figure.
Figure 96 Menu 24.2.2 System Maintenance: Change Console Port Speed
Menu 24.2.2 – System Maintenance – Change Console Port Speed
After you changed the console port speed on your ZyAIR, you must also make the same
change to the console port speed parameter of your communication software.
19.3 Log and Trace
Your ZyAIR provides the error logs and trace records that are stored locally.
166
DESCRIPTION
Displays the system name of your ZyAIR. This information can be changed in
Menu 1 – General Setup.
Refers to the routing protocol used.
Refers to the ZyNOS (ZyXEL Network Operating System) system firmware
version. ZyNOS is a registered trademark of ZyXEL Communications
Corporation.
Refers to the country code of the firmware.
Refers to the Ethernet MAC (Media Access Control) of your ZyAIR.
This is the IP address of the ZyAIR in dotted decimal notation.
This shows the subnet mask of the ZyAIR.
This field shows the DHCP setting of the ZyAIR.
Console Port Speed: 9600
Press ENTER to Confirm or ESC to Cancel:
Chapter 19 System Information and Diagnosis