Ap+Bridge Mode - ZyXEL Communications ZyAIR G-5100 User Manual

Table 14 Wireless: Bridge/Repeater (continued)
LABEL
Active
Remote Bridge MAC
Address
PSK
Enable Spanning
Tree Protocol (STP)

5.5.3 AP+Bridge Mode

Click the WIRELESS link under ADVANCED. Select AP+Bridge in the Operating Mode
drop-down list box to display the screen as shown next. In this screen, you can configure the
ZyAIR to function as an AP and bridge simultaneously. See the section on ZyAIR applications
for more information.
Chapter 5 Wireless LAN
DESCRIPTIONS
Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
Type the MAC address of the peer device in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
When the ZyAIR is in Bridge/Repeater mode, you don't have to enter a pre-
shared key, but the traffic between devices won't be encrypted if you don't. The
peer bridge must use the same pre-shared key and encryption method.
Select the check box to activate STP on the ZyAIR.
ZyAIR G-5100 User's Guide
65