Changing The Initial Default Slice Length; Using The Equalizer; Using The Metronome - Casio XW-PD1 Trackformer User Manual

To change the sample playback method
NOTE
• This function can be used while the pad type is
sample.
1.
Enter the PAD ACTION mode.
2.
Press the pad you want to configure.
3.
Use the sequence step keys to select a
playback method.
Sequence
Display
Settings Step Key
Message
Status
Gate 13, 14: Lit
Loop 13: Flashing Sample playback
One-Shot 14: Flashing Pressing the pad plays
Changing the Initial Default
Slice Length
Use the procedure below to change the initial default
slice length to a value from 1 step to 16 steps.
1.
Enter the SLICE LENGTH mode.
A sequence step key will light to indicate the current
slice length.
2.
Use the sequence step keys to change the
slice length.
Description
The sample is played
once until the end, as
long as the pad is kept
depressed. Releasing
the pad stops sample
playback.
repeats as long as the
pad is depressed.
back the sample once,
all the way through.
Mastering TRACKFORMER Operations

Using the Equalizer

Use the procedure below to adjust four equalizer
frequency bands (HIGH, HIGH MID, LOW MID,
LOW).
1.
Enter the MASTER EQ mode.
2.
Use the pads to raise or lower the four
frequency bands.
• Use the VALUE knob to make fine adjustments.
• You can select a frequency band by pressing a pad,
and then change the frequency to be adjusted by
moving the ASSIGNABLE fader.
Frequency bands LOW LOW MID HIGH MID
■ Selectable Frequencies
Band
LOW 50Hz, 100Hz, 200Hz, 400Hz, 800Hz
LOW MID 100Hz, 250Hz, 630Hz, 1.3kHz, 4kHz
HIGH MID 250Hz, 630Hz, 1.3kHz, 4kHz, 8kHz
HIGH 6kHz, 8kHz, 10kHz, 13kHz, 16kHz

Using the Metronome

Entering the METRONOME mode causes the
metronome to sound. To turn off the metronome, hold
down the FUNCTION selector button again as you
press sequence step key 15.
+12
Max
+6
0
Min
− − 12
HIGH
Frequency
EN-16