Layering; Increasing The Number Of Patterns; After You're Done - Casio XW-PD1 Trackformer User Manual

3. Layering

To change the bank
After pressing the BANK selector button, press the
sequence step key that corresponds to the number of
the bank you want to use.
To delete a bank sequence
After pressing the BANK selector button, hold down
the sequence step key that corresponds to the bank
number of the data you want to delete. The display
shown below appears to indicate that the sequence
recorded in the bank is deleted.
NOTE
• You can also use the FUNCTION CLEAR mode to
delete the settings of a particular bank. This will not
only delete the sequence, it will also initialize the
tones and other settings of the pads. For more
information, see "To delete bank settings" (page
EN-10).
4. Increasing the Number of
Patterns
To enable a pattern group
1.
Press the PATTERN selector button.
2.
Press the sequence step key (11 to 14) that
corresponds to the pattern group you want to
select. A flashing sequence step key
indicates that its pattern group is enabled.
Enabled pattern groups are played back in sequence.
• Pressing the sequence step key of an enabled pattern
group will disable the group.
Pattern group 4
Pattern group 3
Pattern group 2
Pattern group 1
To change the configuration of a pattern
using Pattern Edit
For details about configuring a pattern, see "Changing
the Configuration of a Pattern" (page EN-13).

5. After You're Done

To copy or delete a pattern you created
See "To copy pattern contents" (page EN-11) and "To
delete a pattern" (page EN-10) for information about
these procedures.
To save sequence data
1.
While holding down the FUNCTION selector
button, press the SEQ (WRITE) button.
2.
Use pads 11 (–) and 12 (+) to specify the
number of the sequence data file (100 to 149)
where you want to store the sequence.
3.
Press pad 16 (ENT).
Sequence Creation Flow
EN-5