Sampling Tutorial; Assigning The Sampled Sound To All Of The Pads; Assigning A Sampled Tone To A Specific Pad; Sampling While Holding Down A Sequence Step Key - Casio XW-PD1 Trackformer User Manual

Sampling Tutorial

TRACKFORMER lets you sample the built-in sound
source or an external sound source and assign the
result to a pad. You can also use this function to record
samples while slicing. For information about sampling
basics, refer to the "User's Guide (Basics)" that comes
with TRACKFORMER.
Assigning the Sampled Sound
to all of the Pads
Making all pad tones melody type and then sampling
causes the sampled sound to be assigned to all of the
pads. In this case, a specified pad is the sound source
and all pads are assigned the sampled sound.
1.
Make all pad tones melody type.
2.
Press the SAMPLING selector button.
3.
Press the pad you want to use as the sound
source.
4.
Press the REC selector button.
This starts recording.
5.
Play the sound you want to sample.
6.
Recording will stop when you press the REC
button again or after the specified recording
time elapses.
• The pad you pressed in step 3 will be the sound
source while all pads will be assigned the sampled
sound.
NOTE
• For information about how to make all pad tones
melody type, refer to the "User's Guide (Basics)"
that comes with TRACKFORMER.
Assigning a Sampled Tone to
a Specific Pad
Making all pad tones drum type and then sampling
makes it possible to assign the sampled sound to a
specific pad.
1.
Make all pad tones drum type.
2.
Press the SAMPLING selector button.
3.
Press the pad to which you want to assign the
sampled sound.
4.
Press the REC selector button.
This starts recording.
5.
Play the sound you want to sample.
6.
Recording will stop when you press the REC
button again or after the specified recording
time elapses.
• This assigns the sample sound to the pad you pressed
in step 3.
NOTE
• For information about how to make all pad tones
drum type, refer to the "User's Guide (Basics)" that
comes with TRACKFORMER.
Sampling while Holding Down
a Sequence Step Key
1.
Press the SLICE selector button.
2.
While playing back the sound you want to
sample, press a sequence step key to slice.
• Perform the steps below while holding down the
sequence step key.
3.
Press the SAMPLING selector button.
4.
Press the pad to which you want to assign the
sampled sound.
5.
Press the REC selector button.
This samples the sliced sound.
6.
Recording will stop when you press the REC
button again or after the specified recording
time elapses.
EN-7