Table of Contents
Advertisement
SuperNova 2
Higher gain settings are intended for use with low-output moving-coil cartridges
•
(0.5mV or so).
To reduce Gain to below 40dB (e.g., with a high-output cartridge) use the -20dB
•
Gain Switches located on the Rear Panel.
Note: Always let the unit settle for 60 seconds after any configuration changes are
made before listening. Slowly raise the volume control to insure that the unit is
stable and will not damage your system if the configuration is not set correctly.
Gain Settings (chart)
GAIN
(dB)
40
43.5
46
48
50
51.5
52.7
53.8
55.6
56.3
56.9
57.5
58.4
58.9
59.4
59.9
1.3) Battery Power Supply (Standard configuration)
The SuperNova 2 Battery Power Supply connects to the wall via the supplied power
cord, and to the SuperNova 2 chassis via the supplied ribbon cable. The ribbon cable
clips into the power module at the base of the rear panel. Use care not to bend or
crinkle the ribbon cable.
The connection of the Battery Supply Unit is the same in either Standard or
•
Power Amp-Direct configuration.
Switch the Battery Power Supply to battery mode (green) by pressing the switch
•
on the unit's front panel.
When you have finished listening, switch the unit back into charging mode (red).
•
If you forget to do this, the unit will initiate the charging cycle itself, although we
recommend that you not let this happen frequently. This will maximize the life of
your battery packs.
The unit is guaranteed to operate for at least three hours in battery mode.
•
The LED on the front panel indicates the status of the unit:
9
switch #
1
2
3
4
off off off off
off off off on
off off on off
off off on on
off on off off
off on off on
off on on off
off on on on
on off off off
on off off on
on off on off
on off on on
on on off off
on on off on
on on on off
on on on on
owner's manual
Advertisement
Table of Contents
