Drive Chain Wear Inspection - Honda CB750F2 Owner's Manual

-heck rear axle alignment by making
:':re the chain adjuster index marks (4 )
{gn
with the rear edge (5) of the
.ijusting slots.
l,-'th left and right marks should
-.;,rrespond. If the axle is misaligned,
.:rn the left or right adjusting nut until
re marks correspond on the rear edge
.: the adjusting slots and recheck chain
- ^ 1 -
: I L A .
- ghten the axle nut to specified torque.
--rle nut torque:
9O N'm (9.0 kg-m ,65 lb-ftl
- ghten the adjusting nuts lightly, then
'-3hten the lock nuts by holding the
.:-iusting nuts with a spanner.
Wear inspection:
C h e c k t h e c h a i n w e a r l a b e l w h e n
adjusting the chain. If the red zone (6) on
the label aligns with the arrow mark (7)
on the chain adjuster plates after the
chain has been adjusted to the proper
slack, the chain is excessively worn and
must be replaced. The proper slack is:
3 O - 4 O m m ( 1 . 2 - 1 . 6 i n )
(6) Red zone
(7) Arrow mark
63