ZyXEL Communications Prestige 623R-A1 Quick Start Manual page 3

PORT
2. LAN Use an Ethernet cable to connect to a computer for initial configuration. The port is auto-
10/100M negotiating (can connect at 10 or 100Mbps) and auto-sensing (automatically adjust to the
type of Ethernet cable you use (straight-through or crossover)).
3. POWER Connect to a power source using the power adapter for your region (see your User's
Guide).
After you've made the connections, connect the power cable to a power supply and push in the power button
USB The USB port is useful if you have a USB-enabled computer that does not have a network
interface card for attaching to your Ethernet network. Refer to the Installing USB Driver
section.
RESET You only need to use this button if you've forgotten the Prestige's password. It returns the
Prestige to the factory defaults (password is 1234, LAN IP address 192.168.1.1 etc. see
your User's Guide for details).
Front Panel LED
When the Prestige is turned on, the PWR LED turns on. The SYS and USB LEDs blink while performing
system testing. The SYS LED then turns steady on if the testing is successful. The appropriate LAN and/or
USB LEDs turn on if they are properly connected.
This Quick Start Guide provides a basic configuration that should be compatible with your home or small
office network setup. Refer to the User's Guide for additional configuration instructions.
USB/LAN IP Address
Subnet Mask
DHCP IP Pool
Prestige 623R-A1 ADSL Dual-link Router
to turn on the Prestige. Look at the front panel LEDs.
Prestige Factory Defaults
PRESTIGE FACTORY DEFAULTS
192.168.1.1
255.255.255.0
192.168.1.33 – 192.168.1.64
CONNECTION
Default User name
Default Password
3
admin
1234