Table of Contents
Advertisement
14.2 Fireplace 7100 - Hearth plate installation:
Install the hearth plate by putting it down, as
shown, on the fold located at the bottom of the
hood (Drawing 15). To retain the hearth plate,
the fixing bolt must already have been inserted
into the hole at the back of the fireplace prior to
its installation. Fix the hearth plate in place, at the
required angle, by thightening the nut of the
retaining bolt.
14.3
Installation of the optional decorative
finish on the 7100 table:
table comes with an integrated border that allows
the flush fitting of a decorative covering
Fireplace 7100:
Hearth plate installation
Insert the bolt from the
back of the fireplace. Slip
it in the hole at the top of
hearth plate. Tighten the
nut.
Hearth plate
Rest the bottom of
the hearth plate on the
fold at the base of
the hood
Leave a 2" (50 mm) space
between the hood and
the table for the installation
of the deflector
Floor protection
DRAWING 15
consisting of stone or ceramic tiles (marble,
granite, slate, etc.)
decorative finish or fill up the joints with grout
because you will need to allow for expansion;
this will also facilitate their replacement if
needed. If necessary, fix the tiles slightly with a
few drops of silicone.
REV. 2014-11
The 7100 fireplace
Do not cement in place the
15. Firescreen installation
15.1 Fireplaces 5005, 7005, 7007, 7120: The
firescreen supplied with the fireplace is simply
put in place in the front of the heath. To install it,
tilt it slightly to slide it in position. It will be
retained on each side by the "U" hooks.
15.2 Fireplace 7100: This firescreen comes in
three parts: a detachable firescreen for the front
and two small triangular firescreens for the sides.
.1 The front firescreen is suspended under
the hood retained by a fastener and a fold in
the hood.
.2
The side triangular firescreens
ceramic glass or metal screen) are retained by
the hood and the edge of the wood basket.
The ceramic glass firescreen is retained by an
"S" fastener at the bottom of the glass and
two others on the upper side of the glass
(Drawing no 16). The bottom "S" fastener is
clipped on the edge of the wood basket.
Those of the top are retained by a fold inside
the hood.
firescreen, the "S" fasteners of the metal
firescreen are already soldered in the place
on the firescreen frame.
metallic triangles are also available to be
installed over the lateral triangular
firescreens for those who want to limit ash
dispersal on the sides.
Fireplace 7100:
Glass triangular firescreens
Hood
Fold
Wood
basket
DRAWING 16
Page 14
Contrary to the ceramic glass
Small black
Top "S" fasteners retained by
a fold in the hood
Ceramic glass
Bottom fastener
retained by the
wood basket
(of
Hide quick links:
Advertisement
Table of Contents
