Part 1: Installation; Important Notice; Listed Chimneys; Typical Installation - Les Foyers Don-Bar 9000 Installation, Operation And Maintenance Manual

PART 1: INSTALLATION

1. IMPORTANT NOTICE

WARNING: Any modification, change, or
substitution of any fireplace component and/or
not following the installation, operation, and
maintenance instructions will void the
warranty and can put your security at risk.
1.1 Before installation begins, carefully read the
manual and contact your local building
department to determine whether a building
permit is required to install a fireplace.
1.2 The installation must follow the instructions
in this manual and local building codes. If there is
a conflict, you must follow the more restrictive
measures.
1.3 For your security, enlist the services of a
professional fireplace fitter for the installation.
1.4 Before lighting your first fire, read the
instructions in Part 2 regarding Security,
Operation and Maintenance.
1.5 Your fireplace produces heat and provides
great ambiance but it should not be used as the
main source of heating.

2. Listed chimneys

2.1 Listed factory-built chimneys: Your Don-
Bar fireplace is designed to be installed with any
prefabricated chimney bearing the ULC-S604 or
UL-103HT label. The chimney inside diameter
shall be 10" (250 mm). If the total height of the
installation (from floor to rain cap) is more than
20 feet (6000 mm), a chimney of 8-inch I.D. (200
mm) can be installed.
REV. 2014-10

Typical Installation

Round Top
Storm Collar
Attic
Insulation
Don-Bar
Ceiling
Support
Fireplace
DON-BAR 9000
Floor
Protection
DRAWING 1
Page 5
Factory-built
insulated Chimney
10 inches I.D. (See
also art. 2.1 for
other diameter.)
Roof Support
Flashing
Attic insulation
Shield/Fire stop
Radiation/Dust
Shield
Glass
firescreen
air wash
system