Pizzacraft PizzaQue PC7001 Owner's Manual page 8

MASTERBUILT PRO 22.5" CLIP CONFIGURATION:
5a.
Attach clip, with opening facing upward, to hole in center of rear panel. Then, attach 2 clips to side panels (1
on each side panel) so the opening of the clip is facing upward as shown below. Secure all 3 clips with M5x8
screws and M5 nuts.
Pull rear clip all the way up
in slot and tighten securely
WEBER 22.5" CLIP CONFIGURATION:
5b.
Attach side panel clips and rear panel clip (Qty 5 total -- 2 on each side panel and 1 on the rear panel). Clips near
front edge and clip in rear panel are mounted with the opening facing down, while the clips near the middle of
side panels are mounted with the opening facing up. Secure all clips with M5x8 screws and M5 nuts.
8
Notice how individual clips are oriented