Pizzacraft PizzaQue PC7001 Owner's Manual page 10

ASSEMBLY INSTRUCTIONS FOR 18.5 IN KETTLE GRILL
Rotate side panels toward each other until the holes on the back edge of both side panels line up (some force will be
2.
needed). Use M5x8 screws and M5 nuts to secure the side panels together at back edge. NOTE: Rear panel will not be
needed for 18.5 in grill kit
Align attachment holes for pizza stone supports with designated side panel holes (make sure that the tabs closer to the
3.
outer edge of the pizza stone supports are face up). Secure supports using M5x8 screws and M5 nuts.
Note the direction of the pizza stone support tabs
10
FRONT
Align top and bottom holes
on back edges of side panels
Make sure outer tabs are face
up for 18.5" kit setup
TOP VIEW