Pizzacraft PizzaQue PC7001 Owner's Manual page 11

Attach thermometer by aligning probe and pins with designated holes in the (right) side panel. Secure with thermometer
4.
probe nut. Loosen M5x15 screws, slide the front support tabs over the exposed threaded area, inside the nut and press
all the way down (orient them as shown below). Adjustments may be necessary as tolerances of the front support tabs
can vary slightly. Tighten M5x15 screws to secure front support tabs.
MASTERBUILT PRO 18.5" CLIP CONFIGURATION:
5a.
Attach rear clip (with opening facing down) to hole (3rd from bottom) on back edge of side panels. Then attach clips to
holes near center of each side panel (with opening facing upward -- as shown below). Secure with M5x8 screws and M5
nuts.
WEBER 18.5" CLIP CONFIGURATION:
5b.
Attach clips to holes near center of each side panel (with opening facing upward -- as shown above). Then add clips
(opening facing downward) to clip holes near front of side panels. Finally, attach rear clip to 2nd hole from bottom with
the opening facing downward (as shown below). Secure all clips with M5x8 screws and M5 nuts.
thermometer
thermometer
Note: the side panel clips attached near the front edge are for WEBER KETTLE
GRILLS ONLY and should not be used with the MASTERBUILT PRO
front support tabs
front support tabs
11