NPG DVD-T 901H Instruction Manual page 7

System Setup
Video Setup Page
--VIDEO SETUP-
BRIGHTNESS
CONTRAST
Set up output video quality .
BRIGHTNESS : adjust video brightness .
CONTRAST : adjust video contrast.
HUE
HUE : adjust video hue .
SATURATION : adjust video saturation . SHARPNESS :
adjust video saturation .
SATURATION
SHARPNESS
DOWNMIX
LT/RT : select this item when playing discs with PRO Logic Dolby stereo .
Sound in center and surround channels wil be distributed into stereo channel
Speaker Setup Page
EXIT SETUP
after decoding .
STEREO : normal stereo signal outputs when the player is at 2 channel
-SPEAKER SETUP-
VSS : virtual surround sound
DOWNMIX
OFF : Set up the function,you can setup 5.1 ch output.
LT/RT
STEREO
VSS OFF
OFF ON
SUBWOOFER
CENTER DELAY
REAR DELAY
BASS MODE
Digital Setup Page
--DIGITAL SETUP-
LINEOUT/RFREMOD
OP MODE
DYNAMIC RANGE
DUAL MONO
STEREO/MONO L/MONO R/MIX MONO
EXIT SETUP
1. Output mode
LINE OUT : do linear compression for input signal and suit night with low volume .
RF REMOD : suit daytime with high volume .
2.Dynamic range
Select this item to adjust linear compression ratio to get different compression effects when "OP MODE" is set as "LINE OUT".
At FULL , the audio signal has the largest VPP while the smallest one at OFF .
3.Dual mono
Set signal output modes of L/R channel : stereo , mono left, mono right and mix mono .
Designs and instruction to change without prior notice !
-10-
output mode .
Others
idance ForTroubleshooting
Refer to the following solutions if encounter cases as follows :
Fault Symtptom Possible Causes
No power Power plug isn't inserted well
Batteries run out
Front end of remote controller does not aim at the
receiving window
Video wire is off-line
Didn't set TV at corresponding video mode
No disc
Playing null Disc is not compatible
Disc is placed upside down
Audio wires are off-line
Dumb speaker Missetting for audio function
Misoperation of external amplifier
Intermittent sound, distorted Unclean disc
image Scratched or curled disc
"INVAL ID KEY"on TV screen Misoperation
Operating null
Built-in microcomputer failure resulted from
thunder, static , etc.
No coaxial output Unready or misconnection
Note: As a p pl yi n g microcomputer control , th e p la ye r may d i spl a y in co n f u si o n because of much d i st r u b a n ce . In
that case , switch off the power for at least 10 seconds to return to normal .
Key Parameters
DVD : Compressed digital video and audio
MPEG 4 : Compressed digital video and audio
VCD : Compressed digital video and audio
Compatible discs CD : Uncompressed diqital audio
MP3 : Compressed diqital audio
CD-R: Recordinq disc
Work voltaqe : AC 100-240V / 60/50Hz
Max power consumption : 20W
Video Video output: 1.0i0.2V(P-P)i75|
Frequency : 20Hz-20kHz(48kHz modulation)
SNR: |89dB(A-weighting)
Audio dynamic range : |80dB
Audio output: (Analog audio) 2 . 0 ( + 0 . 2 / - 1 . 0 ) V r m s
Digital audio output: coaxial
Analog audio output: 5.1 channels
Output Component video output :Y Pb/Cb Pr/Cr, SCART
S-video output
Composite video output
-11-
Gu
Solutions
Insert it into socket tightly
Replace new ones
Aim at the receiving window
Connect as "System Connection"
Set TV at the right video mode
Insert disc
Insert compatible disc
upward
Connect as "System Connection"
Reset
Operate correctly
Wipe it with clean soft cloth
Replace a new one
Refer to operating instruction
Restart the unit
Reconnection