The Rear Panel - TP-Link TL-WA901ND User Manual

1.4.2 The Rear Panel

Viewed from left to right, the following parts are located on the rear panel of TL-WA901ND.
ON/OFF: The switch for the power.
POWER: The power port connects to the power adapter provided with the TL-WA901ND
450Mbps Wireless N Access Point.
Ethernet: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a
router.
WPS/RESET: This button is used for both WPS and Reset function. To use the WPS function,
press it for less than five seconds; to use the RESET function, press it for more than five seconds.
 Used as RESET button:
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on System Tools -> Factory Defaults page in the
Router's Web-based Utility.
2) Use the WPS/RESET button: With the Router powered on, press and hold the
WPS/RESET button (more than 5 seconds) until the SYS LED becomes quick-flash from
slow-flash. Then release the button and wait the Access Point to reboot to its factory
default settings.
TL-WA901ND 450Mbps Wireless N Access Point User Guide
Figure 1-2
4