The Rear Panel - TP-Link TL-WA500G User Manual

1.3.2 The Rear Panel

Viewed from left to right, the following parts are located on the rear panel of TL-WA500G.
Wireless antenna：The external antenna is used to transmit and receive wireless data.
RESET: The Reset button is used to restore the AP's factory default settings. There are two ways
to reset the Access Point's factory defaults:
Method one: With the Router powered on, use a pin to press and hold the Reset button
(about 5 seconds) until the System LED becomes quick-flash from slow-flash. And then
release the button and wait the router to reboot to its factory default settings.
Method two: Restore the default settings from "System Tools > Factory Defaults" of the
Modem's Web-based management page.
Note:
Ensure the AP is powered on before it restarts completely.
LAN: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a router.
POWER: The power port connects to the power adapter provided with the TL-WA500G 54M
Wireless Access Point.
TL-WA500G 54M Wireless Access Point User Guide
Figure 1-2 TL-WA500G rear panel
6