Table of Contents
Advertisement
TL-WA7110ND
1.4.2
The Rear Panel
Viewed from left to right, the following parts are located on the rear panel of TL-WA7110ND.
POWER: The power port connects to the power adapter provided with the TL-WA7110ND.
MAIN (PoE): One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or
a router, and is capable of 12V Power over Ethernet output.
SECONDARY: This port is used as a secondary Ethernet port to connect to a network device,
such as a switch or a router.
WPS/RESET: This button is used for both WPS and Reset function. To use the WPS function,
press it for less than five seconds; to use the RESET function, press it for more than five seconds.
Used as RESET button:
There are two ways to reset to the Router's factory defaults:
1)
Use the Factory Defaults function on System Tools -> Factory Defaults page in the
Router's Web-based Utility.
2)
Use
the
and
hold
becomes quick-flash from slow-flash. Then release the button and wait the Access
Point to reboot to its factory default settings.
Used as WPS button:
If you have client devices, such as wireless adapters, that support Wi-Fi Protected Setup,
then you can press this button to quickly establish a connection between the Access Point
and client devices and automatically configure wireless security for your wireless network.
Wireless antenna: The external antenna is used to transmit and receive wireless data.
150Mbps High Power Wireless Access Point User Guide
Figure 1-2 Rear Panel sketch
WPS/RESET
button:
the WPS/RESET button (more than 5 seconds) until the SYS LED
With
the
Router
5
powered
on,
press
Advertisement
Table of Contents
