Table of Contents
Advertisement
Send
Anonymous
CID
Billing Signal (*)
CPC Delay
CPC Duration
Send Flash event
SIP Encrypt
PPPoE retry period
(*)
System Log Server
(*)
System Log Type
(*)
Submit [Button]
Reset [Button]
3.9
System Auth.
3.9.1
In System Authority you can change your login name and password.
3.10 Save Change
3.10.1 In Save Change you can save the changes you have done. If you want to use new setting
in the DW IP Phone, You have to click the Save button. After you click the Save button, the
DW IP Phone will automatically restart and the new setting will effect.
will not be responded.
Default setting is No (do not activate). Once activated the device will not
send its own number.
Default setting is Disabled (do not activate). Once activated the device
will send a signal to notify about the billing status (Polarity Reversal,
Tone_12K, Tone_16k)
Default is 2 seconds, allows the system the ability to adjust the time taken
to lower the voltage to 0V upon disconnection.
Default value is 0ms (do not lower any voltage). Specifies how long the
voltage will remain in ms when it is lowered to 0V.
Default setting is Disabled (do not activate). Provides two methods for
sending flash event messages; DTMF Event and SIP Info.
Default setting is Disabled (do not activate). SIP's encryption method,
four
options
to
WALKERSUN2.
Only works under environments that provide these
services.
Default value is 5 seconds, range is from 5~255. Specifies the time
taken to redial when PPPoE dialing fails.
Specifies the location of the System log server where log information will
be stored.
Default setting is None (do not activate). Specifies the format of system
log messages, four to choose from; None, Call Statistics, Debug
Information and Both.
Save setting value.
Clean all setting.
Support FXS Port
choose
from;
INFINET,
41/54
IP Phone
User Manual
Support FXS Port
AVS,
WALKERSUN1,
Dynamix IP Phone User Manual
Advertisement
Table of Contents
