Inverter Operation - SamplexPower SA-1500-112 User Manual

3-7. Inverter Operation

To operate the power inverter, turn it on by using the ON/OFF switch on the
front panel. The power inverter is now ready to deliver AC power to your
loads. If you are operating several loads from the power inverter, turn them
on separately after the inverter has been turned on.
This will ensure that the power inverter does not have to deliver the starting
currents for all the loads at once.
3-7-1. Unpack and inspect the power inverter, check to see that the power
switch in the OFF position.
3-7-2. Connect the cables to the power input terminals on the year panel of
power inverter.
The terminal is positive (+) and black terminal is negative (-).
Insert the cables into the terminals and tighten allen nut to clamp the
wires securely.
3-7-3. Before proceeding further, carefully check that cable you have just
connected does tie negative terminal of inverter to the negative output
power source.
3-7-4. Connect the cable from the negative terminal of the inverter to the
negative terminal of the power source. Make a secure connection.
WARNING!
Make sure all the DC connections are tight (torque to
9-10 ft-lbs, 11.7-13Nm).
overheat and could result in a potential hazard.
WARNING!
Reverse polarity connection will blow a fuse in inverter
and may permanently damage the inverter.
Damage caused by reverse polarity connection is not
covered by warranty.
Loose connections will
14