Break-In Procedures - Suzuki DR-Z400SY General Information Manual

1-6 GENERAL INFORMATION

BREAK-IN PROCEDURES

During manufacturing only the best possible materials are used and all machined parts are finished to a
very high standard. It is still necessary to allow the moving parts to "BREAK-IN" before subjecting the engine
to maximum stresses. The future performance and reliability of the engine depends on the care and restraint
exercised during its early life. Refer to the following break-in engine speed recommendations.
Keep to these brake-in throttle positions during the break-in period.
Break-in throttle position
Initial 800 km (500 miles): Less than 1/2 throttle
Up to 1 600 km (1 000 miles): Less than 3/4 throttle
Upon reaching an odometer reading of 1 600 km (1 000 miles) you can subject the motorcycle to full
throttle operation for short periods of time.