Troubleshooting Guide - Duraflame 10QI072ARA Instruction Manual Enclosed

This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to
NOTE:
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Modifications not approved by the party responsible for compliance could void user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
REPLACING THE REMOTE CONTROL BATTERY
When the remote control stops operating or its range seems reduced, it is time to replace the battery with new ones.
1. The battery compartment is located on the back end of the remote.
2. Press and slide the battery door open and remove the old battery.
3. Insert 2pcs AAA batteries, checking that the + and - sides of the battery match inside the battery compartment.
4. Replace the battery compartment door.
CAUTION:
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure the batteries are installed correctly with regard to polarity (+ and -).
• Remove batteries from equipment which is not to be used for an extended period of time.
• Remove used batteries promptly.
NOTE:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbonzinc), or rechargeable (nicad, nimh, etc) batteries.
Caution for ingestion.
DISPOSAL OF USED BATTERIES
Battery may contain hazardous substances which could endanger the environment and human health.
This symbol marked on the battery and/ or packaging indicates that used battery shall not be treated as
municipal waste. Batteries should be disposed of at an appropriate collection point for recycling.
By ensuring the used batteries are disposed of correctly, you will help preventing potential negative
consequences for the environment and human health. The recycling of materials will help to conserve
natural resources.
For more information about collection and recycling of used batteries, please contact your local
municipality or your waste disposal service.
PROBLEM
1. Heater does not blow warm air.
2. Low air outlet speed and higher
temperature.
TROUBLE SHOOTING GUIDE
MODEL 10QI072ARA
1a. The ambient temperature is higher than the thermostat setting.
1b. Unplug the unit from the wall outlet for 2 hours. After 2 hours plug the
unit back into wall outlet, and operate as normal.
3c. Check if the air inlet is blocked or the air filter is dirty and needs to be cleaned.
2a. Check if the air inlet is blocked or the air filter is dirty and needs to be cleaned.
SOLUTION
E-7