Buick Enclave Owner's Manual page 389

7. Pull on the cable to make sure it
is secure.
8. Make sure the metal tube is
centered at the striker. Push
the tube toward the front of the
vehicle.
9. Close the liftgate and make sure
it is latched properly.
Storing the Tools
A. Tool Bag
B. Wing Bolt
C. Jack
Put back all tools as they
were stored in the jack storage
compartment and put the
compartment cover back on.
1. Ensure that the bottom of the
jack is facing toward you.
2. Replace the tool bag (A).
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
3. Turn the jack (C) on its side
and place down on the holding
bracket.
4. Reinstall the wing bolt (B) by
turning clockwise.
5. To replace the cover, line up the
tab at the front of the cover with
the notch in the cover opening.
Push the cover in place and
make sure that the rear clips
are in the slots and push the
cover closed.
Store the center cap or the plastic
bolt on wheel covers until a full size
tire is put back on the vehicle. When
you replace the compact spare with
a full size tire, reinstall the bolt on
wheel covers or the center cap.
Hand tighten them over the wheel
nuts, using the wrench.
10-77