Zanussi ZCI68300WA User Manual page 23

Location of the appliance
You can install your freestanding appliance
with cabinets on one or two sides and in the
corner.
Minimum distances
Dimension
A
B
Levelling
Use small feet on the bottom of appliance to
set same level of cooker top surface with other
surfaces
The anti-tilt protection
Caution! You must install the anti-tilt
protection (A+B). If you do not install it
the appliance can tilt.
Before you install anti-tilt protection, adjust the
appliance to the correct height.
www.zanussi.com
B
A
A
mm
2
685
The anti-tilt protection has two parts (A+B).
You can find the anti-tilt protection (B) on right
or left side of the rear wall of the appliance
(See fig. 1). You must install the anti-tilt pro-
tection (A) on the wall. The distance of the
hole of the anti-tilt protection (A) from the floor
is about 816 mm. Make sure you install the an-
ti-tilt protection (A) at the correct height.
Screw it into the solid material or use applica-
ble reinforcement.
Check that the anti-tilt protection projects min-
imum 20 mm into the hole in the back of the
appliance (B) when you push the appliance
(See fig. 2). If the space between the bench
cupboards is greater than the width of the ap-
pliance, you must adjust the side measurement
to centre the appliance. Make sure that the
surface behind the appliance is smooth.
1
2
Electrical installation
Warning! Only a qualified and
competent person must do the electrical
installation.
The manufacturer is not responsible if you
do not follow safety precautions from the
chapter "Safety information".
This appliance is supplied without a main plug
or a main cable.
60 mm
50 mm
A
B
23