BT 300 User Manual page 10

10 Setting up
Battery low warning –
Parent unit
When the batteries are low –
approximately within 1 hour
of running out – the Parent
unit will emit a low battery alert
and the low battery indicator
on the unit will flash red.
To speed up the charging
process turn the Parent unit
off when charging if it's not
being used.
You can still use your Parent
unit to monitor your baby even
when the batteries are low,
provided it remains plugged in
and on charge.
WARNING
Always use rechargeable
batteries in the Parent unit.
Only use the recommended
type – 2 x AA NiMH 1300mAh
batteries. Using other types
could permanently damage
the unit. Charge the batteries
as instructed in this user guide.
The Parent unit can still be used
when it is on charge.
If you experience any problems, please call the Helpline on Freephone 0800 145 6789* or visit bt.com/producthelp
2250 Baby Monitor 300 UG Iss2.[2].indd 10
Baby unit
1. Plug the remaining power adapter cable into the
socket marked on the back of the Baby unit
and plug the other end into the mains power and
switch on.
Switch on and link the Parent and Baby units
1. Press and hold the
1 second. The nightlight will briefly illuminate and
then the green Link indicator will flash.
2. Press and hold the
until all the LEDs on the unit briefly illuminate. The
green Link indicator will flash.
Once the units are linked, the green Link indicators
on the Parent and Baby units will stop flashing and
remain a steady green. The units are now ready to use.
button on the Baby unit for
button on the Parent unit
10/04/2014 11:06