Problem Solution - Worx WX372.3 Safety And Operating Manual

7. AUTOMATIC SPINDLE LOCK
The Automatic Spindle Lock allows you to
use as a regular screwdriver. You can give
an extra twist to firmly tighten a screw,
loosen a very tight screw or continue working
when the battery energy has expired. For
manual screwdriver purposes, the Chuck is
automatically locked when the tool is off.
8. SIGHT LIGHT
The Sight Light (8) allows you to keep a clear
view under less illuminated circumstances.
To turn on the Light simply press the On/Off
Switch. When you release the On/Off Switch,
the light will go out.
9. DRILLING
Drilling
Set the Torque adjustment ring to the
"Drilling without impact" symbol
safety clutch is deactivated in the "Drilling"
position.
Impact Drilling
Set the Torque adjustment ring to the
"Impact drilling" symbol
10
drilling" position, the safety clutch is
deactivated and the maximum power is
always effective.
Move the drill bit into the workpiece,
applying only enough pressure to keep
the bit cutting. Do not force or apply side
pressure to elongate a hole.
Tungsten carbide drill bits should
always be used for concrete and
masonry. When drilling in metal, only
use HSS drill bits in good condition.
Always use a magnetic bit holder (not
included) when using short screwdriver
bits. When screw-driving, apply a small
quantity of liquid soap or similar to the
screw threads to ease insertion.
10. DISPOSAL OF AN EXHAUSTED
BATTERY PACK
To preserve natural resources, please
recycle or dispose of the Battery Pack
properly. This Battery Pack contains
Li
Lithium batteries. Consult your local waste
authority for information regarding available
Lithium-Ion cordless
hammer drill
. The
. In the "Impact
recycling and/or disposal options. Discharge
your Battery Pack by operating your drill,
then remove the Battery Pack from the
drill housing and cover the Battery Pack
connections with heavy-duty adhesive tape
to prevent short circuit and energy discharge.
Do not attempt to open or remove any of the
components.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The Forward and Reverse Switch, which is
on top of the trigger, is positioned in the lock
function. Unlock the Forward and Reverse
Switch putting it into the required rotation
position. Push the trigger and the drill will
start to rotate (See Fig. B).
2. THE DRILL STOPS BEFORE THE
SCREW IS COMPLETELY TIGHTENED.
WHY?
Verify the torque position of the Torque
Adjustment Ring, you can find the Torque
Adjustment Ring between the Chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 22 is the
highest torque (screw driving force). Position
is for drill operation. Regulate the Torque
Adjustment Ring to a higher position to reach
the best result (See Fig. E).
3. I CAN NOT FIT THE BATTERY INTO
THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED Light should turn on when the battery is
charging.
4. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and having
not used a Battery Pack for a prolonged time
will reduce the Battery Pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions
such as large screws into hard wood will use
WX372.3 WX372.5