Nikon SMZ745T Instructions Manual page 22

2 Epi arm
Slightly loosen the clamp knob on the
arm. Screw in the mounting screw at
the end of the Epi arm into the left or
right screw hole (for mounting an arm
for halogen illuminator) on the arm of
the stand while turning the joint. Then,
securely tighten the nut using the
supplied wrench.
Screw the mounting screw at the other
end of the Epi arm into the screw hole
on the lamphouse as described above.
Set the lamphouse in a position for easy
viewing, and tighten the clamp knob.
Lighting area adjustment (for G-LS only)
4
You can adjust the lighting area by moving the lamp socket back and
forth. Adjust the lighting area to allow easy viewing.
Attaching filters (for C-DSLS only)
5
Rotate and remove the filter cap at the end of
the lamphouse and insert a filter. Use filters
that have a diameter of 33 mm and a width of
1.5 to 2 mm.
20
Clamp knob
Simultaneously
clamps two
arms/joints.
Arm
Joint
Nut
Mounting
screw
Filter
ø33 mm
Filter cap
Wrench