System Requirement; Chapter 2 Connecting The Wireless Bridge To Your Network; Chapter 4 Installing The Usb Drivers For The Wireless Bridge; Installing The Driver Software For Windows 98 - GRE GINA User Manual

GRE Wireless LAN

1.3 System Requirement :

1. Computer with USB support or Ethernet connection
2. Windows 98, Millennium, 2000 Professional
3. Wireless bridge (2)
4. Ethernet Cross Over Cable if connecting Wireless AP/Bridge directly to Ethernet PC
(Optional)

Chapter 2 Connecting the Wireless Bridge to Your Network

1. Locate an optimum location for the Wireless Bridge. The best place for your Wireless bridge
is usually at the center of your wireless network, with line of sight to all of your mobile
stations.
2. Fix the direction of the antenna. Try to place it in a position, which can best cover your
wireless network. Normally, the higher you place the antenna, the better the performance will
be. The antenna's position enhances the receiving sensitivity.
3. Connect an RJ-45 connector to the Wireless Bridge. Then, connect the other end of the
Ethernet cable to a switch or hub. The Wireless Bridge will then be connected to your 10/ 100
Network.
4. Connect the AC Power Adapter to the Wireless Bridge's Power Socket. Only use the power
adapter supplied with the Wireless bridge. Use of a different adapter may result in
product damage.
5. The Hardware Installation is complete.
Chapter 3 Configuring the Wireless Bridge
The Wireless bridge can be configured one of two ways, through the AP/Bridge DFU Utility or the
SNMP Manager.
AP/Bridge DFU Utility
The AP Utility can be used when configuring the Wireless Bridge through a USB connection and
is compatible with Windows 98, Millennium, and 2000.
SNMP Manager
The Wireless Bridge SNMP Manager can be used when configuring the Wireless Bridge through
an Ethernet connection and is compatible with Windows 98, Millennium, and 2000.
DEFAULT SETTINGS:
IP Address : 192.168.0.1
SubNet Mask : 255.255.255.0
ESSID : GINA
Mode: Access Point
Chapter 4 Installing the USB Drivers for the Wireless AP/Bridge

4.1 Installing the Driver Software for Windows 98

1. Windows 98 will automatically identify the Wireless AP/Bridge, once it is connected to the PC,
and prompt you to install the necessary driver. Make sure that the Setup CD is inserted into
your CD-ROM drive and click the Next button on the Add New Hardware Wizard screen to
proceed.
GINA Access Point/Bridge User Guide
Page 2