GRE GINA User Manual page 10

GRE Wireless LAN
•
DTIM: Set the DTIM period. Determines at which interval the AP will send its broadcast
traffic. Default value is 4 beacons.
•
Receive Antenna: Set the Receive Antenna among the following options Left, Right or
Diversity, to determine which antennas are used for reception.
•
Transmit Antenna: Set the Transmit Antenna among the following options Left, Right or
Diversity, to determine which antennas are used for transmission.
•
User Community: Indicates the user's password. The default pasword is "public"
•
User Access: Indicates the user's access rights.
•
Administrator Community: Indicates the administrator's password. The default password is
"public".
•
Administrator Access: Indicates the Administrator's access rights.
•
Manufacturer Community: Indicates the manufacturer's password.
•
Manufacturer Access: Indicates the manufacturer's access rights.
•
Gateway IP Address: Network Gateway
•
IP Filtering: Enable/ Disable the possibility to allow only IP protocol packets to pass through
the WLAN and any other protocol packets filtered out.
•
DHCP client: Enable/ Disable automatic IP Address assignment by the DHCP server
Primary Port: Determines the Wireless Bridge's IP Address.
•
Primary Port: The interface which determines the DHCP server (EthernetPort/ Wireless
Port).
•
Authorization Algorithm: Enable/ Disable the association with authorized MAC Addresses
stations.
•
SNMP traps: Enabled/ Disabled SNMP traps, which are the messages indicating the actions
related to the Wireless AP/Bridge that have taken place.
•
WEP 128 keys #1-# 4: The default key that will be used. May be edited if WEP type is 128
bits.
C. Under the window that appears, there are four options:
The "Get" button in order to view the current parameters of the Wireless Bridge
The "Modify" button does not work in this section.
The "Set" button does not work in this section.
The "Exit" button to exit this utility.
GINA Access Point/Bridge User Guide
Page 7