Bluetooth Module Cable - HP EliteBook 8740W Service Manual

Bluetooth module cable

NOTE:
Before removing the Bluetooth module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a.
b.
c.
d.
e.
Remove the Bluetooth module cable:
1. Release the Bluetooth module cable (1) from the opening in the base enclosure.
2. Disconnect the Bluetooth module cable (2) from the system board.
3. Detach the Bluetooth module cable (3) from the base enclosure. The Bluetooth module cable is
attached to the base enclosure with double-sided tape.
4. Remove the Bluetooth module cable.
Reverse this procedure to install the Bluetooth module cable.
Downloaded from LpManual.com Manuals
The Bluetooth module cable is included in the Cable Kit, spare part number 596040-001.
Battery on page
Optical drive (see Optical drive on page
drive on page 55)
Keyboard (see Keyboard on page
Switch cover (see Switch cover on page
Display assembly (see Display assembly on page
Top cover (see Top cover on page
47), and then remove the following components:
54) or secondary hard drive (see
63)
67)
76)
86)
Component replacement procedures
Secondary hard
89