HP EliteBook 8740W Service Manual page 58

3. Lift the right side of the hard drive cover (2), swing it up and to the left, and then remove the
cover (3). The hard drive cover is included in the Plastics Kit, spare part number 596044-001.
4. Loosen the captive Phillips screw (1) that secures the hard drive to the computer.
5. Grasp the Mylar tab on the hard drive and slide the hard drive (2) to the left to disconnect it from
the system board.
6. Remove the hard drive (3) from the hard drive bay.
7. If it is necessary to replace the hard drive bracket, remove the four Phillips PM3.0×3.0
screws (1) that secure the bracket to the hard drive.
50 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals