Installing The Sra Appliance - Dell SonicWall SRA 4200/1200 Getting Started Manual

SRA 4200/1200 Deployment Scenarios
Gateway Deployment
Device Scenario
SonicOS Enhanced SRA on New DMZ
3.1 or higher:
• TZ Series
• PRO Series
SRA on Existing
• NSA E-Class
(SonicOS 5.0+) DMZ
• NSA Series
(SonicOS 5.0+)
SRA on LAN
SonicOS Standard SRA on a New DMZ
3.1 or higher:
• TZ Series
• PRO Series
SRA on Existing
DMZ
SonicOS Standard SRA on the LAN
3.1 or higher:
• TZ Series
• PRO Series
Dell SonicWALLs
with legacy firmware
Third-Party Gateway
Device
Conditions or
Requirements
• OPT or unused interface
• New DMZ configured for NAT
or Transparent Mode
• No unused interfaces
• One dedicated interface in use
as an existing DMZ
• No unused interfaces
• No dedicated interface for a
DMZ
• Open OPT or X2 interface
• New DMZ configured for either
NAT or Transparent Mode
• Provide Dell SonicWALL deep
packet inspection security
services (optional)
• OPT or X2 interface in use with
an existing DMZ
• Provide Dell SonicWALL deep
packet inspection security
services (optional)
• Not planning to use Dell
SonicWALL deep packet
inspection security services
• Interoperability with a third-
party gateway device

Installing the SRA Appliance

1. Plug one end of the power cord into the
Dell SonicWALL SRA 1200/4200 and the other into an
appropriate power outlet.
2. Turn on the power switch located on the rear of the
appliance next to the power cord.
The 'PWR' LED on the front panel lights up blue when the
appliance is turned on. The 'TEST' LED lights up yellow
and may blink for up to a minute while the appliance
performs a series of diagnostic tests. When the 'TEST' LED
is no longer lit, the Dell SonicWALL SRA 1200/4200 is
ready for configuration.
PWR
If the 'TEST' or 'ALARM' LEDs remain lit, or if the 'TEST'
LED blinks red after the Dell SonicWALL SRA 1200/4200
has booted, restart the appliance. For more troubleshooting
information, refer to the Dell SonicWALL SRA
Administrator's Guide.
3. Connect one end of an Ethernet cable into the 'X0' port of
your Dell SonicWALL SRA 1200/4200. Connect the other
end of the cable into the computer you are using to
manage the Dell SonicWALL SRA 1200/4200.
Dell SonicWALL SRA 4200/1200 Getting Started Guide
TEST ALARM
11