General Information; Care Of Glass And Plated Parts - Napoleon The Bayfield GDS25N Installation And Operating Instructions Manual

6
1.4

gENErAL INFOrmATION

The blower power cord must be connected into a properly grounded receptacle. The grounding prong must not
be removed from the cord plug.
for your SatISfactIoN, thIS Stove haS beeN teSt-fIreD to aSSure ItS operatIoN aND
qualIty!
Minimum inlet gas supply pressure is 4.5 inches water column for natural gas and 11 inches water column for
propane. Maximum inlet gas pressure is 7 inches water column for natural gas and 13 inches water column for
propane. When the valve is set to "HI", the manifold pressure under flow conditions is 3.5 inches water column
for natural gas and 10 inches water column for propane. When the fireplace is installed at elevations above
4,500ft, and in the absence of specific recommendations from the local authority having jurisdiction, the certi-
fied high altitude input rating shall be reduced at the rate of 4% for each additional 1,000ft.
Expansion / contraction noises during heating up and cooling down cycles are normal and to be expected.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convert-
ible for use with other gases, unless a certified kit is used.
Maximum input is 24,500 bTU/hr for natural gas. Maximum output for natural gas is 19,600 bTU/hr at an ef-
ficiency of 80%. Maximum input is 23,000 BTU/hr for propane. Maximum output for propane gas is 18,400 BTU/
hr at an efficiency of 80%.
This stove is approved for closet or recessed installations, as well as for bathroom, bedroom and bed-sitting
room installations and is suitable for mobile home installations. The natural gas model can be installed in a
mobile home that is permanently positioned on its site and fueled with natural gas.
1.5

CArE OF gLASS ANd pLATEd pArTS

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE ABRASIVE
CLEANERS TO CLEAN GLASS OR PLATED PARTS.
Buff lightly with a clean dry soft cloth. Clean the glass after the first 10
hours of operation with a recommended fireplace glass cleaner.
Thereafter clean as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
Refer to "REPLACEMENT PARTS" to find out what this product is
equipped with. Use only replacement glass available from your
Authorized dealer.
DO NOT SUBSTITUTE MATERIALS.
TP - CARE OF GLASS AND PLATED PARTS
W415-0547 / D / 11.14.08