Initialization; Machine Initialization Procedure - Casio CE-7000 Dealer's Manual

Initialization

Machine initialization procedure

For CE-7000, TK-7000/7500, TK-6000/6500, TK-T500
Note: If your register has the clerk lock, be sure to pull out the clerk key.
1. Plug the power cord into an AC outlet.
2. Set the mode switch to OFF position.
3. While holding down j, set the mode switch to PGM.
4. Release j.
You should see "0000000000" on the display.
If 10 zeros are not shown or another character are shown,
immediately set the mode switch to OFF and restart from
the beginning of this procedure.
5. Enter 11-digit program code from the worksheet.
6. Press s to register the program code.
(Wait until beep twice.)
7. In case of installing inline system,
enter 3-digit program code from the worksheet.
(For TK-6000/6500 without inline option, do NOT enter any value.)
8. Press s to register the program code.
Please turn on and initialize the registers in order, if your registers are connected with inline.
The ID number of registers are defined automatically.
(Do NOT turn off the register(s) until all register has been initialized.)
CE-7000/TK-7000/TK-7500/TK-T500/TK-6000/TK-6500 Dealer's Manual
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
RECEIPT JOURNAL
FEED FEED
RECEIPT JOURNAL
FEED FEED
s
D D ~ D D
11 10 2 1
(refer to Initialize 1)
s
D D D
3 2 1
(refer to Initialize 2)
After completion of initialization and program
loading, initialization receipt is issued.
Version 1.0.1
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
23