Table of Contents
Advertisement
1
Product Specific and Important Safety Information
A. Appliance Certification / Specifications
MODEL:
Absolute43 Pellet Stove
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
135-S-32-2
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 1509-12, ULC-S627-00,
EPA Method 28 & 5G
ELECTRICAL
115 VAC, 60 Hz, Start 4.0 Amps, Run
RATING:
3.0 Amps
GLASS
5mm mirrored ceramic glass
SPECIFICATION:
The Absolute43 is Certified to comply with
2015 particulate emission standards. Not
approved for sale after May 15, 2020.
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E 1509-04, ULC-S627-00, (UM) 84-HUD
B. Mobile Home Approval
This appliance is approved for mobile and manufactured
home installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class "PL" or "L" connector pipe.
A Harman
Outside Air Kit must be installed in a mobile home
®
installation.
!
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
!
Risk of Fire! Hearth & Home Technologies disclaims any
responsibility for, and the warranty and agency listing will
be voided by the below actions.
4
WARNING
WARNING
Harman® • Absolute43 Owner's Manual_R5 • 2015 -___ • 07/15
C. BTU & Efficiency Specifications
EPA Certification Number:
EPA Certified Emissions:
*EPA Default Efficiency:
**Actual Tested Efficiency:
***EPA BTU Output:
****BTU Input
Vent Size:
Hopper Capacity:
Fuel
*An efficiency based on EPA historical data of 78%
**Actual tested efficiency and data collected during EPA
emissions test
***A range of BTU outputs based on EPA default efficiency
and the burn rates from the low and high EPA tests
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU's which is the average BTU's from
a pound of pellets.
This wood heater has a manufacturer-set minimum low burn
rate that must not be altered. It is against federal regulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overfire
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
Harman
is a registered trademark of Hearth & Home
®
Technologies.
967-14
1.8 g/hr
78%
69.3%
33,900
43,000
3 Inch
52 lbs
Wood Pellets
3-90-777000c
Hide quick links:
Advertisement
Table of Contents
