Regulating The Flame; Switching Off - Miele TX3587 Operating And Installation Instructions

Operation

Regulating the flame

Switching off

18
Control the flame so that it does not spread out beyond the
sides of the pan. As the outer part of the flame is much hotter
than the centre, the tips of the flames should stay beneath the
pan base. Flame tips which extend beyond the sides of the
pan merely warm up the air in the room and can also damage
pan handles and increase the risk of injury.
The burners can be regulated at any level between the
strongest and weakest flame. Exception: the wok burner.
There is a resistance on the wok burner at the 6 o'clock
position to prevent you turning the control to the high or low
setting unintentionally. To move from the high to the low
setting, you need to press the control down to be able to
pass the 6 o'clock position.
^ To move from the high to the low setting, turn the control
anti-clockwise until it meets a resistance. Then press it
down and continue to turn it past the resistance before
releasing it. You can now select the setting you require.
^ To move from the low to the high setting, turn the control
clockwise until it meets a resistance. Then press it down
and continue to turn it past the resistance before releasing
it. You can now select the setting you require.
^ Turn the control clockwise to position "ß".
This stops the flow of gas and the flame goes out.
Do not turn the control knob clockwise past "ß".