Rear View; Transporting The Dryer - Miele TMV 840 WP Operating Instructions Manual

Installation and connection

Rear view

a Protruding lid for holding when mov‐
ing the dryer (see arrows)
b Accessories for external drainage of
condensed water: hose clip, adapter
and hose holder
c Hose for external drainage of con‐
densed water
d Mains connection cable
e Communication module slot

Transporting the dryer

To manoeuvre the dryer out of its pack‐
ing case to its installation site, hold it by
– the front feet
– and the lid where it protrudes at the
back of the appliance.

Only transport the dryer as
shown in the following illustrations.
76

If transporting the dryer at an an‐
gle, only tip towards the left side.

If the tumble dryer has not been
transported as described, then it
must be left to stand for at least 1
hour before it is connected to the
electricity supply.
Otherwise the heat pump can be
damaged.