Miele TMV 840 WP Operating Instructions Manual page 66

Heat pump dryer
Hide thumbs Also See for TMV 840 WP:
Table of Contents

Advertisement

Problem solving guide
Problem
Information
Clean out airways
lights up at the end of a
programme
Clean out airways
Clean the fluff filter and
check the airways.
lights up after a pro‐
gramme has been can‐
celled
Empty container
Empty the container or
check the drain hose.
lights up after a pro‐
gramme has been can‐
celled
Information
Fill condensate container
Information
Please open and close the
door
66
Cause and remedy
There is a build-up of fluff in the airways.
 Clean the fluff filters.
 Clean the plinth filter.
See "Cleaning and care".
To switch off the message:
 Confirm OK.
An excessive amount of fluff has built up.
 Clean the fluff filters.
 Clean the plinth filter.
Clean the airways:
 Clean the area underneath the plinth filter.
 Clean the heat exchanger.
To switch off the messages:
 Switch the dryer off and back on again.
The condensed water container is full or there is kink
in the drain hose.
 Empty the container.
 Check the drain hose.
To switch off the message:
 Open and close the door while the dryer is switch‐
ed on or switch the dryer off and back on again.
This is to remind you that water is taken from the
condensed water container when the Steam smooth‐
ing programme is being used.
The condensed water container must be filled with
water to at least the –min– marker.
 Confirm OK.
 Open and close the door to enable drying.
This it to remind you to load the laundry when the
Steam smoothing programme is selected.
 Load the laundry in the drum.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents